Quark D2000 Development Board

Overview

The Intel® Quark™ microcontroller D2000 package is shipped as a 40-pin QFN component.

Quark D2000 Development Board

Intel® Quark™ microcontroller D2000 contains the following items:

  • On-board components:
    • Accelerometer/Magnetometer sensor
    • UART/JTAG to USB convert for USB debug port
  • Expansion options:
    • “Arduino Uno” compatible SIL sockets ( 3.3V IO Only )
  • Other connectors:
    • 1x USB 2.0 Device Port - micro Type B
    • On-board coin cell battery holder
    • 5V input a screw terminal/header (external power or Li-ion)
    • EEMBC power input header

Hardware

General information for the board can be found at the Intel Website, which includes both schematics and BRD files.

The Intel® Quark™ Microcontroller D2000 Development Platform supports the familiar open standard Arduino Uno Rev 3.0 physical interface and is mechanically compatible with Uno Rev 3.0. It does not support the 6 pin ICSP Header.

Supported Features

Interface Controller Driver/Component
MVIC on-chip interrupt_controller
UART on-chip serial port-polling; serial port-interrupt
SPI on-chip spi
I2C on-chip i2c
GPIO on-chip gpio
PWM on-chip pwm

Programming and Debugging

The D2000 board configuration details are found in the project’s tree at boards/x86/quark_d2000_crb.

To build an application for this board, the following call is needed:

$ make BOARD=quark_d2000_crb <make target>

Flashing

  1. Since the board has a built-in JTAG; it is possible to flash the device through the USB only. Set the following jumpers to enable the built-in JTAG:

    Jumper UART Common JTAG Name
    J9 Open X X TDO
    J10 Open X X TDI
    J11 Open X X TRST
    J12 X N/A X TMS
    J17 X N/A X TCK

  2. Connect the D2000 via USB to the host computer.

  3. Once the binary is built, it can be flashed to the device by:

    $ make BOARD=quark_d2000_crb flash

Debugging

To debug an application on the Quark D2000 board, follow these steps. As an example, we are using the Hello World application.

  1. Go to the application’s folder:.

    $ cd $ZEPHYR_BASE/samples/hello_world

  2. Verify the final binary is in outdir/quark_d2000_crb/zephyr.elf.

  3. To enable the debug process, enter:

    $ make BOARD=quark_d2000_crb debug