PWM: Blink LED¶
Overview¶
This is a sample app which blinks a LED using PWM.
The LED will start at a blinking frequency of 1 Hz. Every 4 seconds, the blinking frequency will double. When the blinking frequency reaches 64 Hz, the blinking frequency will be halved every 4 seconds until the blinking frequency reaches 1 Hz. This completes a whole blinking cycle. This faster-then-slower LED blinking cycle repeats forever.
Wiring¶
Nucleo_F401RE, Nucleo_L476RG, STM32F4_DISCOVERY, Nucleo_F302R8¶
Connect PWM2(PA0) to LED
Nucleo_F103RB¶
Connect PWM1(PA8) to LED
Nucleo_L496ZG¶
No special board setup is necessary because there are three on-board LEDs (red, green, blue) connected to the Nucleo’s PWM.
Hexiwear K64¶
No special board setup is necessary because there is an on-board RGB LED connected to the K64 PWM.
nrf52840_pca10056¶
No special board setup is necessary because there is an on-board LED connected.
Building and Running¶
This sample can be built for multiple boards, in this example we will build it for the nrf52840_pca10056 board:
west build -b nrf52840_pca10056 samples/basic/blink_led
west flash
After flashing the image to the board, the user LED on the board should start to blinking as discussed in overview