The latest development version of this page may be more current than this released 3.7.0 version.

Blue Clover PLT Demo V2 nRF52832

Overview

The Blue Clover PLT Demo V2 is an open source (OSWHA certified) hardware product, featuring the Nordic Semiconductor nRF52832 ARM Cortex-M4F MCU and several useful external peripherals.

The Nordic Semiconductor nRF52832 ARM Cortex-M4F MCU features the following:

  • ADC

  • CLOCK

  • FLASH

  • GPIO

  • I2C

  • MPU

  • NVIC

  • PWM

  • RADIO (Bluetooth Low Energy)

  • RTC

  • Segger RTT (RTT Console)

  • SPI

  • UART

  • WDT

Blue Clover PLT Demo V2 nRF52832

Hardware

  • nRF52832 ARM Cortex-M4F processor at 64 MHz

  • 512 KB flash memory and 64 KB of SRAM

  • Bosch BMI270 IMU

  • Sensiron SHT30 Humidity and Temperature sensor

  • Murata PKLCS1212E4001R1 Piezo Buzzer

  • Battery connector and charger for 3.7 V lithium polymer batteries

  • 4 APA102C Addressable LEDs

  • Reset button (can be configured as user button)

  • 1 User button

  • Tag-Connect TC2030-FP 6-pin Debug Connector

Supported Features

The Blue Clover PLT Demo V2 board configuration supports the following hardware features:

Interface

Controller

Driver/Component

ADC

on-chip

adc

CLOCK

on-chip

clock_control

FLASH

on-chip

flash

GPIO

on-chip

gpio

I2C(M)

on-chip

i2c

MPU

on-chip

arch/arm

NVIC

on-chip

arch/arm

PWM

on-chip

pwm

RADIO

on-chip

Bluetooth

RTC

on-chip

system clock

RTT

Segger

console

SPI(M/S)

on-chip

spi

UART

on-chip

serial

WDT

on-chip

watchdog

Connections and IOs

Push buttons

  • RESET = P0.21

  • STATUS = P0.26

UART

  • TXD = P0.06

  • RXD = P0.08

Power

  • USB-C Connector

  • JST-PH Battery Connector

NFC

  • U.FL Connector, on NFC1/P0.09, NFC2/P0.10

Programming and Debugging

Applications for the blueclover_plt_demo_v2/nrf52832 board configuration can be built and flashed in the usual way (see Building an Application and Run an Application for more details).

Flashing

Flashing Zephyr onto the blueclover_plt_demo_v2/nrf52832 board requires an external programmer. The programmer is attached to the SWD header.

Build the Zephyr kernel and the LED strip sample application.

west build -b blueclover_plt_demo_v2/nrf52832 samples/drivers/led_apa102

Flash the image.

west build -b blueclover_plt_demo_v2/nrf52832 samples/drivers/led_apa102
west flash

References