The latest development version of this page may be more current than this released 3.7.0 version.

Cellular modem

Overview

This sample consists of a simple application which powers on the modem, brings up the net interface, then sends a packet with pseudo random data to the endpoint test-endpoint.com, which is a publicly hosted server which runs the Python script found in the server folder. DNS is used to look up the IP of test-endpoint.com.

Notes

This sample uses the devicetree alias modem to identify the modem instance to use. The sample also presumes that the modem driver creates the only PPP network interface.

Setup

Start by setting up the devicetree with the required devicetree node:

/dts-v1/;

/ {
        aliases {
                modem = &modem;
        };
};

&usart2 {
        pinctrl-0 = <&usart2_tx_pa2 &usart2_rx_pa3 &usart2_rts_pa1 &usart2_cts_pa0>;
        pinctrl-names = "default";
        current-speed = <115200>;
        hw-flow-control;
        status = "okay";

        modem: modem {
                compatible = "quectel,bg9x";
                mdm-power-gpios = <&gpioe 2 GPIO_ACTIVE_HIGH>;
                mdm-reset-gpios = <&gpioe 3 GPIO_ACTIVE_HIGH>;
                status = "okay";
        };
};

Next, the UART API must be specified using CONFIG_UART_INTERRUPT_DRIVEN=y or CONFIG_UART_ASYNC_API=y. The driver doesn’t support UART polling.

Lastly, the APN must be configured using CONFIG_MODEM_CELLULAR_APN="".