ENE KB1200_EVB
Overview
The KB1200_EVB kit is a development platform to evaluate the ENE KB1200 series microcontrollers. This board needs to be mated with part number KB1200.
Hardware
ARM Cortex-M4F Processor
512KB Flash and 320KB RAM
ADC & GPIO headers
SER1, SER2 and SER3
FAN PWM interface
ENE Debug interface
Supported Features
The following features are supported:
Interface |
Controller |
Driver/Component |
|---|---|---|
NVIC |
on-chip |
nested vector interrupt controller |
ADC |
on-chip |
adc controller |
CLOCK |
on-chip |
reset and clock control |
GPIO |
on-chip |
gpio |
I2C |
on-chip |
i2c port/controller |
PINMUX |
on-chip |
pinmux |
PMU |
on-chip |
power management |
PSL |
on-chip |
power switch logic |
PWM |
on-chip |
pulse width modulator |
TACH |
on-chip |
tachometer sensor |
SER |
on-chip |
serial port-polling; serial port-interrupt |
WDT |
on-chip |
watchdog |
Other hardware features are not currently supported by Zephyr (at the moment)
System Clock
The KB1200 MCU is configured to use the 96Mhz internal oscillator with the on-chip DPLL to generate a resulting EC clock rate of 96MHz/48MHz/24MHz/12MHz. See Processor clock control register (refer 5.1 General Configuration)
Programming and Debugging
Flashing
If the correct headers are installed, this board supports SWD Debug Interface.
To flash with SWD, install the drivers for your programmer, for example: SEGGER J-link’s drivers are at https://www.segger.com/downloads/jlink/
Debugging
Use SWD with a J-Link