The latest development version of this page may be more current than this released 4.0.0 version.

GD32F350R-EVAL

Overview

The GD32F350R-EVAL board is a hardware platform that enables design and debug of the GigaDevice F350 Cortex-M4F High Performance MCU.

The GD32F350RBT6 features a single-core ARM Cortex-M4F MCU which can run up to 108-MHz with flash accesses zero wait states, 128kB of Flash, 16kB of SRAM and 55 GPIOs.

Hardware

GD32F350RBT6 MCU
AT24C02C 2Kb EEPROM
4 x User LEDs
4 x User Push buttons
1 x USART (RS-232 at J2 connector)
1 x POT connected to an ADC input
Headphone interface
Micro SD Card Interface
2.4’’ TFT-LCD (36x48)
GD-Link on board programmer
J-Link/SWD connector

For more information about the GD32F350 SoC and GD32F350R-EVAL board:

Supported Features

The board configuration supports the following hardware features:

Peripheral	Kconfig option	Devicetree compatible
NVIC	N/A	`arm,v7m-nvic`
SYSTICK	N/A	N/A
USART	`CONFIG_SERIAL`	`gd,gd32-usart`
PINMUX	`CONFIG_PINCTRL`	`gd,gd32-pinctrl-af`
ADC	`CONFIG_ADC`	`gd,gd32-adc`

Serial Port

The GD32F350R-EVAL board has one serial communication port. The default port is USART0 with TX connected at PA9 and RX at PA10.

Programming and Debugging

Before programming your board make sure to configure boot and serial jumpers as follows:

J4: Select 2-3 for both (labeled as L)
J13: Select 1-2 position (labeled as USART)

Using GD-Link

The GD32F350R-EVAL includes an onboard programmer/debugger (GD-Link) which allows flash programming and debugging over USB. There is also a SWD header (J3) which can be used with tools like Segger J-Link.

Build the Zephyr kernel and the Hello World sample application:
```
west build -b gd32f350r_eval samples/hello_world
```
Run your favorite terminal program to listen for output. On Linux the terminal should be something like /dev/ttyUSB0. For example:
```
minicom -D /dev/ttyUSB0 -o
```
The -o option tells minicom not to send the modem initialization string. Connection should be configured as follows:
- Speed: 115200
- Data: 8 bits
- Parity: None
- Stop bits: 1
To flash an image:
```
west build -b gd32f350r_eval samples/hello_world
west flash
```
You should see “Hello World! gd32f350r_eval” in your terminal.

To debug an image:

west build -b gd32f350r_eval samples/hello_world
west debug