Ganymed Break-Out-Board (BOB)
Overview
Note
All software for the Ganymed Break-Out-Board (BOB) is experimental and hardware availability is restricted to the participants in the limited sampling program.
The Ganymed board hardware provides support for the Ganymed sy1xx series IoT multicore RISC-V SoC with optional sensor level.
The SoC has the following core features:
32-Bit RSIC-V 1+8-core processor, up to 500MHz
1x Data Acquisition Unit
8x Data Processing Unit
Event Bus
MicroDMA
4096 KB Global SRAM
64 KB Secure SRAM
512 KB Global MRAM
512 KB Secure MRAM
CLOCK
RAM
32x GPIO
4x TWIM
4x I2S
7x SPI
3x UART
1x TSN
1x CAN-FD
3x ADC
Ganymed Break-Out-Board (BOB) equipped with SY120 GBM (Credit: Sensry)
Ganymed Break-Out-Board (BOB) equipped with SY120 GEN1 (Credit: Sensry)
Hardware
The Ganymed BOB has:
Assembly options for the SoC include
SY120-GBM - Generic Base Module without top level sensors
SY120-GEN1 - Generic Module type 1 with top level sensors (Bosch BME680 - SPI1 , Bosch BMA456 - SPI0, Bosch BMG250 - SPI2, STMicro MIS2DH - I2C0)
power section for on-board power generation and power measurement (selectable)
40-pin JTAG connector (compatible to Olimex ARM-JTAG-OCD-H)
USB over FTDI (connected to UART0)
Header for I/Os and additional configuration
Supported Features
The ganymed-bob/sy120-gbm board supports the following hardware features:
Interface |
Controller |
Driver/Component |
|---|---|---|
SAADC |
on-chip |
adc |
CLOCK |
on-chip |
clock_control |
MRAM |
on-chip |
flash |
GPIO |
on-chip |
gpio |
TWIM |
on-chip |
i2c |
PWM |
on-chip |
pwm |
GRTC |
on-chip |
counter |
RTT |
Segger |
console |
SPI(M/S) |
on-chip |
spi |
SPU |
on-chip |
system protection |
UART |
on-chip |
serial |
TSN |
on-chip |
ethernet MAC |
CAN |
on-chip |
CAN |
Other hardware features have not been enabled yet for this board.
The ganymed-bob/sy120-gen1 board includes all hardware features of the ganymed-bob/sy120-gbm board and comes additionally
with these features:
Interface |
Controller |
Driver/Component |
|---|---|---|
BME680 |
on-chip |
environment sensor |
BMA456 |
on-chip |
acceleration sensor |
BMG250 |
on-chip |
gyrosope sensor |
MIS2DH |
on-chip |
vibration sensor |
Other hardware features have not been enabled yet for this board.
Power
USB type-C
external 5V power source
Programming and Debugging
Applications for the ganymed-bob/sy120-gbm board can be
built, flashed, and debugged in the usual way. See
Building an Application and Run an Application for more details on
building and running.
Testing the Ganymed BreakOut Board
Test the Ganymed with a Blinky sample. The sample output should be:
Hello World! ganymed-bob/sy120-gbm