voltage-divider
Vendor: Generic or vendor-independent
Note
An implementation of a driver matching this compatible is available in drivers/sensor/voltage_divider/voltage.c.
Description
Description for a voltage divider, with optional ability to measure
resistance of the upper leg.
Properties
Properties not inherited from the base binding file.
Name |
Type |
Details |
|---|---|---|
|
|
Resistance of the lower leg of the voltage divider
This property is required. |
|
|
Resistance of the full path through the voltage divider.
If absent or zero the driver assumes that the upper leg is a
resistance-based sensor.
|
|
|
Control power to the voltage divider inputs.
If present the corresponding GPIO must be set to an active level
to enable the divider input.
|
|
|
Duration to delay sampling after enabling the circuitry with
`power-gpios`. In most cases the switched voltage rail will
require some non-zero time to settle to its final value. The
default value of 100us should be sufficient in most situations.
Default value: |
Deprecated properties not inherited from the base binding file.
(None)
Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the “voltage-divider” compatible.
Name |
Type |
Details |
|---|---|---|
|
|
Channels available with this divider configuration.
This property is required. |
|
|
indicates the operational status of a device
Legal values: See Important properties for more information. |
|
|
compatible strings
This property is required. See Important properties for more information. |
|
|
register space
See Important properties for more information. |
|
|
name of each register space
|
|
|
interrupts for device
See Important properties for more information. |
|
|
extended interrupt specifier for device
|
|
|
name of each interrupt
|
|
|
phandle to interrupt controller node
|
|
|
Human readable string describing the device (used as device_get_binding() argument)
See Important properties for more information. This property is deprecated. |
|
|
Clock gate information
|
|
|
name of each clock
|
|
|
number of address cells in reg property
|
|
|
number of size cells in reg property
|
|
|
DMA channels specifiers
|
|
|
Provided names of DMA channel specifiers
|
|
|
Provided names of IO channel specifiers
|
|
|
mailbox / IPM channels specifiers
|
|
|
Provided names of mailbox / IPM channel specifiers
|
|
|
Power domain specifiers
|
|
|
Provided names of power domain specifiers
|
|
|
Number of cells in power-domains property
|
|
|
Do not initialize device automatically on boot. Device should be manually
initialized using device_init().
|
|
|
Property to identify that a device can be used as wake up source.
When this property is provided a specific flag is set into the
device that tells the system that the device is capable of
wake up the system.
Wake up capable devices are disabled (interruptions will not wake up
the system) by default but they can be enabled at runtime if necessary.
|
|
|
Automatically configure the device for runtime power management after the
init function runs.
|
|
|
List of power states that will disable this device power.
|