zephyr,w1-gpio
Vendor: Zephyr-specific binding
Note
An implementation of a driver matching this compatible is available in drivers/w1/w1_zephyr_gpio.c.
Description
These nodes are “w1” bus nodes.
Zephyr W1 GPIO node
This defines a one-wire driver through GPIO bit-banging.
For example:
/ {
w1: w1 {
compatible = "zephyr,w1-gpio";
gpios = <&gpio0 13 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN | GPIO_PULL_UP)>;
};
};
Above:
- w1 is pin 13 on gpio0. The gpio is active when the pin is high, is
configured as an open-drain, and has a pull-up resistor.
Implementation details:
- Most drivers require the selected gpio to support open drain, this enables onewire
devices to lower the signal when the SOC set the signal high.
- Ensure pullup is strong enough (4.7K according to the specification). Standard pullup in
SOC are usually weak, and may not be strong enough.
Properties
Properties not inherited from the base binding file.
Name |
Type |
Details |
|---|---|---|
|
|
This property is required. |
|
|
Enable the active pullup for the 1-Wire bus.
|
Deprecated properties not inherited from the base binding file.
(None)
Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the “zephyr,w1-gpio” compatible.
Name |
Type |
Details |
|---|---|---|
|
|
indicates the operational status of a device
Legal values: See Important properties for more information. |
|
|
compatible strings
This property is required. See Important properties for more information. |
|
|
register space
See Important properties for more information. |
|
|
name of each register space
|
|
|
interrupts for device
See Important properties for more information. |
|
|
extended interrupt specifier for device
|
|
|
name of each interrupt
|
|
|
phandle to interrupt controller node
|
|
|
Human readable string describing the device (used as device_get_binding() argument)
See Important properties for more information. This property is deprecated. |
|
|
Clock gate information
|
|
|
name of each clock
|
|
|
number of address cells in reg property
|
|
|
number of size cells in reg property
|
|
|
DMA channels specifiers
|
|
|
Provided names of DMA channel specifiers
|
|
|
IO channels specifiers
|
|
|
Provided names of IO channel specifiers
|
|
|
mailbox / IPM channels specifiers
|
|
|
Provided names of mailbox / IPM channel specifiers
|
|
|
Power domain specifiers
|
|
|
Provided names of power domain specifiers
|
|
|
Number of cells in power-domains property
|
|
|
Do not initialize device automatically on boot. Device should be manually
initialized using device_init().
|
|
|
Property to identify that a device can be used as wake up source.
When this property is provided a specific flag is set into the
device that tells the system that the device is capable of
wake up the system.
Wake up capable devices are disabled (interruptions will not wake up
the system) by default but they can be enabled at runtime if necessary.
|
|
|
Automatically configure the device for runtime power management after the
init function runs.
|
|
|
List of power states that will disable this device power.
|