RTS5912 Evaluation Board

Overview

The RTS5912 EVB is a development platform to evaluate the Realtek RTS5912 embedded controller.

For more information about the evb board please see RTS5912_EVB_Schematics [1] and RTS5912_DATASHEET [2]

The board is powered through the +5V USB Type-C connector or adaptor.

The rts5912_evb board supports the hardware features listed below.

on-chip / on-board: Feature integrated in the SoC / present on the board.
2 / 2: Number of instances that are enabled / disabled.
Click on the label to see the first instance of this feature in the board/SoC DTS files.
vnd,foo: Compatible string for the Devicetree binding matching the feature.
Click on the link to view the binding documentation.

Type	Location	Description	Compatible
CPU	on-chip	ARM Cortex-M33F CPU1	`arm,cortex-m33f`
Clock control	on-chip	Realtek RTS5912 System Clock Controller (SCCON)1	`realtek,rts5912-sccon`
Clock control	on-chip	Generic fixed-rate clock provider2	`fixed-clock`
GPIO & Headers	on-chip	Realtek RTS5912 GPIO9	`realtek,rts5912-gpio`
GPIO & Headers	on-chip	Serial Wire - JTAG Connector1	`swj-connector`
Input	on-chip	Realtek RTS5912 keyboard matrix controller1	`realtek,rts5912-kbd`
Interrupt controller	on-chip	ARMv8-M NVIC (Nested Vectored Interrupt Controller)1	`arm,v8m-nvic`
Memory controller	on-chip	Realtek, RTS5912 Battery Backed RAM node1	`realtek,rts5912-bbram`
Pin control	on-chip	Realtek RTS5912 Pin Controller1	`realtek,rts5912-pinctrl`
RTC	on-chip	RTC on Realtek RTS5912 EC1	`realtek,rts5912-rtc`
Serial controller	on-chip	ns16550 UART1	`ns16550`
Serial controller	on-chip	Realtek RTS5912 UART1	`realtek,rts5912-uart`
SRAM	on-chip	Generic on-chip SRAM description1	`mmio-sram`
Timer	on-chip	ARMv8-M System Tick1	`arm,armv8m-systick`
	on-chip	Realtek RTS5912 32-bit slow timer1	`realtek,rts5912-slwtimer`
	on-chip	RTOS Timer on Realtek RTS5912 EC1	`realtek,rts5912-rtmr`
Watchdog	on-chip	Realtek RTS5912 watchdog timer1	`realtek,rts5912-watchdog`

Build Hello World application as you would normally do.
The file zephyr.rts5912.bin will be created if the build system can build successfully. This binary image can be found under file “build/zephyr/”.

Connect Dediprog into header J81 and J82.
Use Dediprog SF600 programmer to write the binary into the external flash U10 at the address 0x0.
Power off the board.
Set the strap pin GPIO108 to high and power on the board.

Using SWD or JTAG with ULINPRO.