BL654 DVK

Overview

The BL654 Development Kit hardware provides support for the Laird BL654 module powered by a Nordic Semiconductor nRF52840 ARM Cortex-M4F CPU.

This development kit has the following features:

  • ADC
  • CLOCK
  • FLASH
  • GPIO
  • I2C
  • MPU
  • NVIC
  • PWM
  • RADIO (Bluetooth Low Energy and 802.15.4)
  • RTC
  • Segger RTT (RTT Console)
  • SPI
  • UART
  • USB
  • WDT
BL654 Development Kit

BL654 Development Kit Board

455-00001 Box Contents

455-00001 (BL654 DVK integrated antenna) Box Contents

More information about the board can be found at the BL654 website [1].

Hardware

Supported Features

The BL654 DVK board configuration supports the following hardware features:

Interface Controller Driver/Component
ADC on-chip adc
CLOCK on-chip clock_control
FLASH on-chip flash
GPIO on-chip gpio
I2C(M) on-chip i2c
MPU on-chip arch/arm
NVIC on-chip arch/arm
PWM on-chip pwm
RADIO on-chip Bluetooth, ieee802154
RTC on-chip system clock
RTT Segger console
SPI(M/S) on-chip spi
UART on-chip serial
USB on-chip usb
WDT on-chip watchdog

Other hardware features are not supported by the Zephyr kernel. See BL654 website [1] for a complete list of BL654 Development Kit board hardware features.

Connections and IOs

LED

  • LED1 (blue) = P0.13
  • LED2 (blue) = P0.14
  • LED3 (blue) = P0.15
  • LED4 (blue) = P0.16

Push buttons

  • BUTTON1 = SW1 = P0.11
  • BUTTON2 = SW2 = P0.12
  • BUTTON3 = SW9 = P0.24
  • BUTTON4 = SW10 = P0.25
  • RESET = SW3 = nReset/IF BOOT

Programming and Debugging

Applications for the bl654_dvk board configuration can be built and flashed in the usual way (see Building an Application and Run an Application for more details); however, the standard debugging targets are not currently available.

Flashing

Follow the instructions in the Nordic nRF5x Segger J-Link page to install and configure all the necessary software. Further information can be found in Flashing. Then build and flash applications as usual (see Building an Application and Run an Application for more details).

Here is an example for the Hello World application.

First, run your favorite terminal program to listen for output.

NOTE: On the BL654 DVK, the FTDI USB should be used to access the UART console.

$ minicom -D <tty_device> -b 115200

Replace <tty_device> with the port where the board nRF52 DK can be found. For example, under Linux, /dev/ttyUSB0.

Then build and flash the application in the usual way.

# From the root of the zephyr repository
west build -b bl654_dvk samples/hello_world
west flash

Debugging

Refer to the Nordic nRF5x Segger J-Link page to learn about debugging Nordic based boards with a Segger IC.

Testing Bluetooth on the BL654 DVK

Many of the Bluetooth examples will work on the BL654 DVK. Try them out:

Testing the LEDs and buttons on the BL654 DVK

There are 2 samples that allow you to test that the buttons (switches) and LEDs on the board are working properly with Zephyr:

You can build and flash the examples to make sure Zephyr is running correctly on your board. The button and LED definitions can be found in boards/arm/bl654_dvk/bl654_dvk.dts.