The GD32V103V-EVAL board is a hardware platform that enables prototyping on GD32VF103VB RISC-V MCU.
The GD32VF103VB features a single-core RISC-V 32-bit MCU which can run up to 108 MHz with flash accesses zero wait states, 128 KiB of Flash, 32 KiB of SRAM and 80 GPIOs.
AT24C02C 2Kb EEPROM
GD25Q16 16Mbit SPI and QSPI NOR Flash
4 x User LEDs
1 x Joystick (L/R/U/D/C)
2 x USART (RS-232 at J1/J2 connectors)
1 x POT connected to an ADC input
USB FS connector
1 x CAN
3.2” RGB-LCD (320x240)
GD-Link on board programmer
For more information about the GD32VF103 SoC and GD32VF103V-EVAL board:
The board configuration supports the following hardware features:
Nuclei ECLIC Interrupt Controller
The GD32VF103V-EVAL board has two serial communications port. The default port is USART0 with TX connected at PA9 and RX at PA10.
Programming and Debugging¶
Before programming your board make sure to configure boot and serial jumpers as follows:
JP2/3: Select 2-3 for both (boot from user memory)
JP5/6: Select 1-2 positions (labeled as