This is the documentation for the latest (main) development branch of Zephyr. If you are looking for the documentation of previous releases, use the drop-down menu on the left and select the desired version.

M5Stack STAMP-C3

Overview

STAMP-C3 featuring ESPRESSIF ESP32-C3 RISC-V MCU with Wi-Fi connectivity for IoT edge devices such as home appliances and Industrial Automation.

For more details see the M5Stack STAMP-C3 1 page.

Supported Features

The STAMP-C3 board configuration supports the following hardware features:

Interface

Controller

Driver/Component

PMP

on-chip

arch/riscv

INTMTRX

on-chip

intc_esp32c3

PINMUX

on-chip

pinctrl_esp32

USB UART

on-chip

serial_esp32_usb

GPIO

on-chip

gpio_esp32

UART

on-chip

uart_esp32

I2C

on-chip

i2c_esp32

SPI

on-chip

spi_esp32_spim

TWAI

on-chip

can_esp32_twai

Prerequisites

Espressif HAL requires WiFi and Bluetooth binary blobs in order work. Run the command below to retrieve those files.

west blobs fetch hal_espressif

Note

It is recommended running the command above after west update.

Building & Flashing

Build and flash applications as usual (see Building an Application and Run an Application for more details).

# From the root of the zephyr repository
west build -b stamp_c3 samples/hello_world

The usual flash target will work with the stamp_c3 board configuration. Here is an example for the Hello World application.

# From the root of the zephyr repository
west build -b stamp_c3 samples/hello_world
west flash

Open the serial monitor using the following command:

west espressif monitor

After the board has automatically reset and booted, you should see the following message in the monitor:

***** Booting Zephyr OS vx.x.x-xxx-gxxxxxxxxxxxx *****
Hello World! stamp_c3

Debugging

As with much custom hardware, the ESP32 modules require patches to OpenOCD that are not upstreamed yet. Espressif maintains their own fork of the project. The custom OpenOCD can be obtained at OpenOCD ESP32 2

The Zephyr SDK uses a bundled version of OpenOCD by default. You can overwrite that behavior by adding the -DOPENOCD=<path/to/bin/openocd> -DOPENOCD_DEFAULT_PATH=<path/to/openocd/share/openocd/scripts> parameter when building.

Here is an example for building the Hello World application.

# From the root of the zephyr repository
west build -b stamp_c3 samples/hello_world -- -DOPENOCD=<path/to/bin/openocd> -DOPENOCD_DEFAULT_PATH=<path/to/openocd/share/openocd/scripts>
west flash

You can debug an application in the usual way. Here is an example for the Hello World application.

# From the root of the zephyr repository
west build -b stamp_c3 samples/hello_world
west debug

References

1

https://docs.m5stack.com/en/core/stamp_c3

2

https://github.com/espressif/openocd-esp32/releases