This is the documentation for the latest (main) development branch of Zephyr. If you are looking for the documentation of previous releases, use the drop-down menu on the left and select the desired version.

gooddisplay,gd7965 (on spi bus)

Vendor: Dalian Good Display Co., Ltd.

Description

GD7965 EPD display controller

Properties

Properties not inherited from the base binding file.

Name

Type

Details

height

int

Height in pixel of the panel driven by the controller

This property is required.

width

int

Width in pixel of the panel driven by the controller

This property is required.

reset-gpios

phandle-array

RESET pin.
The RESET pin of GD7965 is active low. If connected directly the MCU pin should be configured as active low.

This property is required.

dc-gpios

phandle-array

DC pin.
The DC pin of GD7965 is active low (transmission command byte). If connected directly the MCU pin should be configured as active low.

This property is required.

busy-gpios

phandle-array

BUSY pin.
The BUSY pin of GD7965 is active low. If connected directly the MCU pin should be configured as active low.

This property is required.

pwr

uint8-array

Power Setting (PWR) values

This property is required.

softstart

uint8-array

Booster Soft Start (BTST) values

This property is required.

cdi

int

VCOM and data interval value

This property is required.

tcon

int

TCON setting value

This property is required.

spi-max-frequency

int

Maximum clock frequency of device's SPI interface in Hz

This property is required.

duplex

int

Duplex mode, full or half. By default it's always full duplex thus 0
as this is, by far, the most common mode.
Use the macros not the actual enum value, here is the concordance
list (see dt-bindings/spi/spi.h)
  0    SPI_FULL_DUPLEX
  2048 SPI_HALF_DUPLEX

Legal values: 0, 2048

frame-format

int

Motorola or TI frame format. By default it's always Motorola's,
thus 0 as this is, by far, the most common format.
Use the macros not the actual enum value, here is the concordance
list (see dt-bindings/spi/spi.h)
  0     SPI_FRAME_FORMAT_MOTOROLA
  32768 SPI_FRAME_FORMAT_TI

Legal values: 0, 32768

supply-gpios

phandle-array

GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.