This is the documentation for the latest (main) development branch of Zephyr. If you are looking for the documentation of previous releases, use the drop-down menu on the left and select the desired version.


Vendor: Nordic Semiconductor


These nodes are “i2c” bus nodes.

Nordic nRF family TWIM (TWI master with EasyDMA).

This binding can be used for nodes which can represent TWIM
peripherals. A single SoC peripheral ID is often associated with
multiple I2C peripherals, like a TWIM and a TWIS. You can choose
TWIM by setting the node's "compatible" to "nordic,nrf-twim"
and "status" to "okay", e.g. using an overlay file like this one:

    /* This is for TWIM0 -- change to "i2c1" for TWIM1, etc. */
    &i2c0 {
            compatible = "nordic,nrf-twim";
            status = "okay";
            /* other property settings can go here */

This works on any supported SoC, for all TWIM instances.

Note: on nRF51 SoCs, use the "nordic,nrf-twi" binding instead.


Properties not inherited from the base binding file.






Size of a concatenation buffer that the driver is to use for merging
multiple same direction I2C messages that have no RESTART or STOP
flag between them (see e.g. the i2c_burst_write() function) into one
transfer on the bus.

This property must be provided when interacting with devices like
the SSD1306 display that cannot tolerate a repeated start and
address appearing on the bus between message fragments. For many
devices a concatenation buffer is not necessary.

Default value: 16



TWIM peripherals cannot perform write transactions from buffers
located in flash. If such buffers are expected to be used with
a given instance of the TWIM peripheral, this property must be
set to the maximum possible size of those buffers, so that the
driver can reserve enough space in RAM to copy there the contents
of particular buffers before requesting the actual transfers.

If this property is not set to a value adequate for a given
application, write transactions may fail for buffers that are
located in flash, what in turn may cause certain components,
like the DPS310 sensor driver, to not work.

It is recommended to use the same value for this property and for
the zephyr,concat-buf-size one, as both these buffering mechanisms
can utilize the same space in RAM.

Default value: 16



The SDA pin to use.

For pins P0.0 through P0.31, use the pin number. For example,
to use P0.16 for SDA, set:

    sda-pin = <16>;

For pins P1.0 through P1.31, add 32 to the pin number. For
example, to use P1.2 for SDA, set:

    sda-pin = <34>;  /* 32 + 2 */

This property is required.



The SCL pin to use. The pin numbering scheme is the same as
the sda-pin property's.

This property is required.



Initial clock frequency in Hz