STM32 Single Wire UART¶
A simple application demonstrating how to use the single wire / half-duplex UART functionality of STM32. Without adaptions this example runs on STM32F3 discovery board. You need to establish a physical connection between pins PA2 (USART2_TX) and PC10 (UART4_TX).
Add a single_wire_uart_loopback fixture to your board in the hardware map to allow twister to verify this sample’s output automatically.
Building and Running¶
Build and flash as follows, replacig
stm32f3_disco with your board:
west build -b stm32f3_disco samples/drivers/uart/stm32/single_wire west flash
After flashing the console output should not show any failure reports, but the following message repeated every 2s: