-
CONFIG_DISK_FLASH_ERASE_ALIGNMENT¶
Flash device erase alignment in hex
Type: hex
Help¶
This is the start address alignment required by the flash component.
Direct dependencies¶
(DISK_ACCESS_FLASH && SOC_FLASH_NIOS2_QSPI && FLASH && BOARD_ALTERA_MAX10) || (DISK_ACCESS_FLASH && SPI_FLASH_W25QXXDV && FLASH && SPI && BOARD_ARDUINO_101) || DISK_ACCESS_FLASH
(Includes any dependencies from if’s and menus.)
Defaults¶
- 0x10000 if
DISK_ACCESS_FLASH&&SOC_FLASH_NIOS2_QSPI&&FLASH&&BOARD_ALTERA_MAX10 - 0x1000 if
DISK_ACCESS_FLASH&&SPI_FLASH_W25QXXDV&&FLASH&&SPI&&BOARD_ARDUINO_101
Kconfig definitions¶
At boards/nios2/altera_max10/Kconfig.defconfig:32
Included via Kconfig:10 → Kconfig.zephyr:21
Menu path: (top menu)
config DISK_FLASH_ERASE_ALIGNMENT
hex
default 0x10000 if DISK_ACCESS_FLASH && SOC_FLASH_NIOS2_QSPI && FLASH && BOARD_ALTERA_MAX10
depends on DISK_ACCESS_FLASH && SOC_FLASH_NIOS2_QSPI && FLASH && BOARD_ALTERA_MAX10
At boards/x86/arduino_101/Kconfig.defconfig:41
Included via Kconfig:10 → Kconfig.zephyr:21
Menu path: (top menu)
config DISK_FLASH_ERASE_ALIGNMENT
hex
default 0x1000 if DISK_ACCESS_FLASH && SPI_FLASH_W25QXXDV && FLASH && SPI && BOARD_ARDUINO_101
depends on DISK_ACCESS_FLASH && SPI_FLASH_W25QXXDV && FLASH && SPI && BOARD_ARDUINO_101
At subsys/disk/Kconfig:87
Included via Kconfig:10 → Kconfig.zephyr:39 → subsys/Kconfig:16
Menu path: (top menu) → Disk
config DISK_FLASH_ERASE_ALIGNMENT
hex
prompt "Flash device erase alignment in hex" if DISK_ACCESS_FLASH
depends on DISK_ACCESS_FLASH
help
This is the start address alignment required by
the flash component.
(Definitions include propagated dependencies, including from if’s and menus.)