-
CONFIG_USB_VBUS_GPIO¶
Control VBUS via GPIO pin
Type: bool
Help¶
The USB VBUS signal is connected via a GPIO pin.
Direct dependencies¶
(USB_DEVICE_STACK && BOARD_ARDUINO_101) || (USB_DEVICE_STACK && BOARD_QUARK_SE_C1000_DEVBOARD) || (USB && BOARD_TINYTILE) || (GPIO && USB_DEVICE_STACK)
(Includes any dependencies from if’s and menus.)
Defaults¶
- “y” if
USB_DEVICE_STACK&&BOARD_ARDUINO_101 - “y” if
USB_DEVICE_STACK&&BOARD_QUARK_SE_C1000_DEVBOARD - “y” if
USB&&BOARD_TINYTILE
Kconfig definitions¶
At boards/x86/arduino_101/Kconfig.defconfig:55
Included via Kconfig:10 → Kconfig.zephyr:21
Menu path: (top menu)
config USB_VBUS_GPIO
bool
default "y" if USB_DEVICE_STACK && BOARD_ARDUINO_101
depends on USB_DEVICE_STACK && BOARD_ARDUINO_101
At boards/x86/quark_se_c1000_devboard/Kconfig.defconfig:27
Included via Kconfig:10 → Kconfig.zephyr:21
Menu path: (top menu)
config USB_VBUS_GPIO
bool
default "y" if USB_DEVICE_STACK && BOARD_QUARK_SE_C1000_DEVBOARD
depends on USB_DEVICE_STACK && BOARD_QUARK_SE_C1000_DEVBOARD
At boards/x86/tinytile/Kconfig.defconfig:22
Included via Kconfig:10 → Kconfig.zephyr:21
Menu path: (top menu)
config USB_VBUS_GPIO
bool
default "y" if USB && BOARD_TINYTILE
depends on USB && BOARD_TINYTILE
At subsys/usb/Kconfig:78
Included via Kconfig:10 → Kconfig.zephyr:39 → subsys/Kconfig:28
Menu path: (top menu) → USB device stack
menuconfig USB_VBUS_GPIO
bool
prompt "Control VBUS via GPIO pin" if GPIO && USB_DEVICE_STACK
depends on GPIO && USB_DEVICE_STACK
help
The USB VBUS signal is connected via a GPIO pin.
(Definitions include propagated dependencies, including from if’s and menus.)