Renesas Starter Kit+ for RZ/T2M
Overview
The Renesas Starter Kit+ for RZ/T2M is an evaluation and development kit for the RZ/T2M MPU. The board is powered through a 5V input via a DC Power Jack or USB Type-C Connector.
Starter Kit+ for RZ/T2M (Credit: Renesas)
Hardware
The board utilizes the SoC of part no. R9A07G075M24GBG, with 2MB of RAM.
It has several on-board memory components:
SDRAM (256MBit),
NOR Flash (256MBit),
Octa Flash (512MBit),
HyperRAM (512Mbit),
QSPI Serial Flash (512Mbit),
I2C EEPROM (32Kbit).
The communication interfaces include:
Debug interfaces (J-Link, MIPI-10, MIPI-20),
Ethernet,
CAN,
USB,
RS485,
UART,
I2C,
SPI.
Supported Features
Interface |
Controller |
Driver/Component |
|---|---|---|
NVIC |
on-chip |
nested vector interrupt controller |
SYSTICK |
on-chip |
systick |
PINCTRL |
on-chip |
pinctrl |
UART |
on-chip |
serial |
GPIO |
on-chip |
gpio |
Other hardware features are not currently supported by the port.
Connections and IOs
By default, the board is configured for use with:
UART0 connected to the USB serial port (pins K18, K19),
UART3 connected to the PMOD Header (J25, pins H16, G20),
LEDs defined as led0, led1, led2 and led3,
The Zephyr console uses UART0.
Programming and Debugging
Debugging
Connect to the board using the J-Link On-board USB connector. Use west to start the debug server:
west debugserver
Connect GDB to the server and load an application:
target remote :2331
file build/zephyr/zephyr.elf
load