STM32 PM STOP3 mode
Overview
This sample is a minimum application to demonstrate basic power management behavior in a basic blinking LED set up and STM32U5 STOP3 low power mode.
Requirements
At the moment, only nucleo_u575zi_q board is supported.
The board shall have an RTC to use it during the standby mode as a replacement
for LPTIM (which is disabled).
Building and Running
Build and flash examples as follows:
west build -b nucleo_u575zi_q samples/boards/stm32/power_mgmt/stop3
west flash
After flashing, the LED starts to blink.
PM configurations
By default, CONFIG_PM_DEVICE and CONFIG_PM_DEVICE_RUNTIME
are enabled.