The latest development version of this page may be more current than this released 3.7.0 version.

LP50XX RGB LED

Overview

This sample controls up to 12 LEDs connected to a LP50xx driver.

First, for each LED information is retrieved using the led_get_info syscall and printed in the log messages. Next, from an infinite loop, a test pattern (described below) is applied to all the LEDs simultaneously (using the led_write_channels() syscall) and then to each LED one by one (using the led_set_brightness() and led_set_color() syscalls).

Test pattern

For all the LEDs first (using channel API) and then for each LED one by one:

For each color in red green blue white yellow purple cyan orange:

  • set the color

  • turn on

  • turn off

  • set the brightness gradually to the maximum level

  • turn off

Building and Running

This sample can be built and executed on boards with an I2C LP5009, LP5012, LP5018, LP5024, LP5030 or LP5036 LED driver connected. A node matching the the device type binding should be defined in the board DTS files.

As an example this sample provides a DTS overlay for the NXP LPCXpresso11U68 board (boards/lpcxpresso11u68.overlay). It assumes that a I2C LP5030 LED driver (with 10 LEDs wired) is connected to the I2C0 bus at address 0x30.

References