The latest development version of this page may be more current than this released 3.7.0 version.

IS31FL3733 LED Matrix

Overview

This sample controls a matrix of up to 192 LEDs. The sample performs the following test steps in an infinite loop:

• Set all LEDs to full brightness with led_write_channels() API

• Disable upper quadrant of LED array with led_write_channels() API

• Dim each LED in sequence using led_set_brightness() API

• Toggle each LED in sequency using led_on() and led_of() APIs

• Toggle between low or high current limit using is31fl3733_current_limit() API, and repeat the above tests

Sample Configuration

The number of LEDs can be limited using the following sample specific Kconfigs:

• CONFIG_LED_ROW_COUNT

• CONFIG_LED_COLUMN_COUNT

Building and Running

This sample can be run on any board with an IS31FL3733 LED driver connected via I2C, and a node with the issi,is31fl3733 compatible present in its devicetree.

This sample provides a DTS overlay for the NXP FRDM-K22F board (boards/frdm_k22f.overlay). It assumes that the IS31FL3733 LED controller is connected to I2C0, at address 0x50. The SDB GPIO should be connected to PTC2 (A3 on the arduino header)