This is the documentation for the latest (main) development branch of Zephyr. If you are looking for the documentation of previous releases, use the drop-down menu on the left and select the desired version.

hamamatsu,s11059 (on i2c bus)

Vendor: Hamamatsu Photonics K.K.


Hamamatsu Photonics S11059 Color Sensor.  See datasheet at


Properties not inherited from the base binding file.






When present, the high gain is enabled.
The gain ratio is 10 times from low to high.



Integration time (unit is us).
By setting this value to the desired integration time,
the Integration time setting and Manual timing register
values are set automatically.

The default value is 546ms. See datasheet, bottom of page 3.

Default value: 546000



Human readable string describing the sensor. It can be used to
distinguish multiple instances of the same model (e.g., lid accelerometer
vs. base accelerometer in a laptop) to a host operating system.

This property is defined in the Generic Sensor Property Usages of the HID
Usage Tables specification
(, section 22.5).



GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.



Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.