-
CONFIG_USB_VBUS_GPIO_PIN_NUM¶
GPIO pin number
Type: int
Help¶
The number of the GPIO pin to which the USB_VBUS_EN signal is connected.
Direct dependencies¶
(USB_DEVICE_STACK && BOARD_ARDUINO_101) || (USB_DEVICE_STACK && BOARD_QUARK_SE_C1000_DEVBOARD) || (USB && BOARD_TINYTILE) || (USB_VBUS_GPIO && USB_DEVICE_STACK)
(Includes any dependencies from if’s and menus.)
Defaults¶
- 28 if
USB_DEVICE_STACK&&BOARD_ARDUINO_101 - 28 if
USB_DEVICE_STACK&&BOARD_QUARK_SE_C1000_DEVBOARD - 28 if
USB&&BOARD_TINYTILE - 0 if
USB_VBUS_GPIO&&USB_DEVICE_STACK
Kconfig definitions¶
At boards/x86/arduino_101/Kconfig.defconfig:61
Included via Kconfig:10 → Kconfig.zephyr:21
Menu path: (top menu)
config USB_VBUS_GPIO_PIN_NUM
int
default 28 if USB_DEVICE_STACK && BOARD_ARDUINO_101
depends on USB_DEVICE_STACK && BOARD_ARDUINO_101
At boards/x86/quark_se_c1000_devboard/Kconfig.defconfig:33
Included via Kconfig:10 → Kconfig.zephyr:21
Menu path: (top menu)
config USB_VBUS_GPIO_PIN_NUM
int
default 28 if USB_DEVICE_STACK && BOARD_QUARK_SE_C1000_DEVBOARD
depends on USB_DEVICE_STACK && BOARD_QUARK_SE_C1000_DEVBOARD
At boards/x86/tinytile/Kconfig.defconfig:28
Included via Kconfig:10 → Kconfig.zephyr:21
Menu path: (top menu)
config USB_VBUS_GPIO_PIN_NUM
int
default 28 if USB && BOARD_TINYTILE
depends on USB && BOARD_TINYTILE
At subsys/usb/Kconfig:93
Included via Kconfig:10 → Kconfig.zephyr:39 → subsys/Kconfig:28
Menu path: (top menu) → USB device stack → Control VBUS via GPIO pin
config USB_VBUS_GPIO_PIN_NUM
int
prompt "GPIO pin number" if USB_VBUS_GPIO && USB_DEVICE_STACK
default 0 if USB_VBUS_GPIO && USB_DEVICE_STACK
depends on USB_VBUS_GPIO && USB_DEVICE_STACK
help
The number of the GPIO pin to which the USB_VBUS_EN signal is
connected.
(Definitions include propagated dependencies, including from if’s and menus.)