nxp,dcif

Description

NXP DCIF (Display Controller Interface)

Properties

Properties not inherited from the base binding file.

Name

Type

Details

backlight-gpios

phandle-array

LCD backlight control gpio. Driver will initialize this GPIO to active high

This property is required.

power-gpios

phandle-array

Panel power-enable gpio, driven active high once at init and left on. Left blank for a panel whose power rail is not gpio-controlled.

panic-threshold-low

int

Layer 0 FIFO word count below which panic is asserted. The default is 256 words to request urgent memory access before the FIFO underflows.

Default value: 256

panic-threshold-high

int

Layer 0 FIFO word count above which panic is cleared. The default is 512 words to clear panic after the FIFO has refilled.

Default value: 512

data-bus-width

string

DPI output data format of the controller sent to the panel. The default is set to the reset value of RGB565. The enumerator order matches the DCIF HAL dcif_dpi_output_format_t enumeration.

Default value: RGB565

Legal values: RGB888, RBG888, GBR888, GRB888, BRG888, BGR888, RGB555, RGB565, RGB666

ext-ram

phandle

Secondary RAM in which the controller's frame buffer(s) will
be stored. If not defined, the 'zephyr,ram' chosen memory will be used.

pixel-format

int

Initial Pixel format of this controller's output data, which is sent
to a panel directly or to an adapter.
See dt-bindings/display/panel.h for a list of pixel format.

This property is required.

height

int

Height of the panel driven by the controller, with the units in pixels.

This property is required.

width

int

Width of the panel driven by the controller, with the units in pixels.

This property is required.

pinctrl-0

phandles

Pin configuration/s for the first state. Content is specific to the
selected pin controller driver implementation.

pinctrl-1

phandles

Pin configuration/s for the second state. See pinctrl-0.

pinctrl-2

phandles

Pin configuration/s for the third state. See pinctrl-0.

pinctrl-3

phandles

Pin configuration/s for the fourth state. See pinctrl-0.

pinctrl-4

phandles

Pin configuration/s for the fifth state. See pinctrl-0.

pinctrl-names

string-array

Names for the provided states. The number of names needs to match the
number of states.

resets

phandle-array

Reset information

reset-names

string-array

Name of each reset