realtek,rtl8211f

Description

Realtek RTL8211F Ethernet PHY device

Properties

Properties not inherited from the base binding file.

Name

Type

Details

reset-gpios

phandle-array

GPIO connected to PHY reset signal pin. Reset is active low.

int-gpios

phandle-array

GPIO for interrupt signal indicating PHY state change.

realtek,rgmii-delay

string

Configure RTL8211F internal RGMII clock delay mode.

This property is only applicable when the PHY is connected using an
RGMII interface.

- "none": no internal delay
- "id": enable RX and TX delay
- "rxid": enable RX delay only
- "txid": enable TX delay only

Default value: id

Legal values: none, id, rxid, txid

default-speeds

string-array

The selected speeds are used to configure the PHY during initialization

Default value: [10BASE Half-Duplex, 10BASE Full-Duplex, 100BASE Half-Duplex, 100BASE Full-Duplex, 1000BASE Half-Duplex, 1000BASE Full-Duplex]

Legal values: 10BASE Half-Duplex, 10BASE Full-Duplex, 100BASE Half-Duplex, 100BASE Full-Duplex, 1000BASE Half-Duplex, 1000BASE Full-Duplex

timing-role

string

1000BASE-T master/slave role. Omit for IEEE auto resolution (default).

- "forced-master"    - manual MS enable, MS=1
- "forced-slave"     - manual MS enable, MS=0
- "preferred-master" - auto resolution, prefer MS=1
- "preferred-slave"  - auto resolution, prefer MS=0

Use "forced-master" on a direct point-to-point link to a PC/RPi NIC
if the link flaps or caps at 100 Mb (auto master/slave never agrees
with some NICs). Never force the same role on both ends.

Legal values: forced-master, forced-slave, preferred-master, preferred-slave