This is the documentation for the latest (main) development branch of Zephyr. If you are looking for the documentation of previous releases, use the drop-down menu on the left and select the desired version.

renesas,smartbond-regulator

Vendor: Renesas Electronics Corporation

Description

Renesas Smartbond(tm) LDO and DCDC regulators

Properties

Top level properties

No top-level properties.

Child node properties

Name

Type

Details

renesas,regulator-v30-ref-bandgap

boolean

Selects reference source for V30 LDO to Bandgap output.

renesas,regulator-v30-clamp

boolean

Enables clamp that can supply V30 from VBAT.

renesas,regulator-v30-vbus

boolean

Allow V30 to be powered from VBUS.

renesas,regulator-v30-vbat

boolean

Allow V30 to be powered from VBAT.

renesas,regulator-dcdc-vbat-high

boolean

Enable DCDC in high battery voltage mode.

renesas,regulator-dcdc-vbat-low

boolean

Enable DCDC in low battery voltage mode.

renesas,regulator-sleep-ldo

boolean

Enable LDO in sleep mode.

regulator-init-microvolt

int

Voltage set during initialisation

regulator-max-microamp

int

largest current consumers may set

regulator-always-on

boolean

boolean, regulator should never be disabled

regulator-boot-on

boolean

bootloader/firmware enabled regulator.
It's expected that this regulator was left on by the bootloader.
If the bootloader didn't leave it on then OS should turn it on
at boot but shouldn't prevent it from being turned off later.
This property is intended to only be used for regulators where
software cannot read the state of the regulator.

regulator-initial-mode

int

Initial operating mode. The set of possible operating modes depends on the
capabilities of every hardware so each device binding documentation
explains which values the regulator supports.