ti,bq25896-regulator
Description
TI BQ25896 USB OTG boost regulator
USB OTG boost regulator of the TI BQ25896, described as a child node of
the "ti,bq25896" node. The current limits are 0.5 A, 0.75 A, 1.2 A,
1.4 A, 1.65 A, 1.875 A and 2.15 A.
Boost mode also needs the OTG pin of the device to be high.
Examples
bq25896@6b {
compatible = "ti,bq25896";
reg = <0x6b>;
usb_otg_vbus: regulator {
compatible = "ti,bq25896-regulator";
regulator-init-microvolt = <4998000>;
regulator-init-microamp = <500000>;
};
};
Properties
Properties not inherited from the base binding file.
Name |
Type |
Details |
|---|---|---|
|
|
A string used as a descriptive name for regulator outputs
|
|
|
Voltage set during initialisation
|
|
|
smallest voltage consumers may set
|
|
|
largest voltage consumers may set
|
|
|
Current set during initialisation
|
|
|
smallest current consumers may set
|
|
|
largest current consumers may set
|
|
|
boolean, regulator should never be disabled
|
|
|
bootloader/firmware enabled regulator.
It's expected that this regulator was left on by the bootloader.
If the bootloader didn't leave it on then OS should turn it on
at boot but shouldn't prevent it from being turned off later.
This property is intended to only be used for regulators where
software cannot read the state of the regulator.
|
|
|
Regulator should be disabled on boot.
|
|
|
Startup time, in microseconds
|
|
|
Off to on delay time, in microseconds
|
Deprecated properties not inherited from the base binding file.
(None)
Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the “ti,bq25896-regulator” compatible.
(None)