realtek,ameba-sdhost

Description

These nodes are “sd” bus nodes.

AMEBA SD Host controller

Properties

Properties not inherited from the base binding file.

Name

Type

Details

cd-gpios

phandle-array

Card detect pin.

pinctrl-0

phandles

Pin configuration/s for the first state. Content is specific to the
selected pin controller driver implementation.

This property is required.

pinctrl-names

string-array

Names for the provided states. The number of names needs to match the
number of states.

This property is required.

bus-width

int

SD bus width in bits.
Default is 4, as the AMEBA SD host controller is commonly wired
for 4-bit operation on most boards, which provides better
performance than 1-bit mode.
Only 1-bit and 4-bit modes are supported by the hardware.
Boards that require 1-bit mode must explicitly set this property
in the device tree.

Default value: 4

Legal values: 1, 4, 8

max-current-330

int

Max drive current in mA at 3.3V. A value of zero indicates no maximum
is specified by the driver.

Default value: 0

max-current-300

int

Max drive current in mA at 3.0V. A value of zero indicates no maximum
is specified by the driver.

Default value: 0

max-current-180

int

Max drive current in mA at 1.8V. A value of zero indicates no maximum
is specified by the driver.

Default value: 0

max-bus-freq

int

Maximum bus frequency for SD card. This should be the highest frequency
the SDHC is capable of negotiating with cards on the bus.

Default value: 400000

min-bus-freq

int

Minimum bus frequency for SD card. This should be the frequency that
cards first will select when attached to the SDHC bus

Default value: 400000

power-delay-ms

int

time in ms for SDHC to delay when toggling power to the SD card. This
delay gives the card time to power up or down fully

Default value: 500

sd-uhs-modes

string-array

UHS-I bus speed modes the slot supports for SD and SDIO cards. The
host reports a mode only if it is in this list and the controller
supports it. Without this property, the modes the controller
supports are not restricted.

Use this property when a mode the controller supports is not
reliable on the board, for example on a bus that is shared between
slots. A slot where SDR104 tuning fails can be limited to DDR50:

  sd-uhs-modes = "ddr50";

Legal values: sdr50, ddr50, sdr104

mmc-hs200-1_8v

boolean

The host controller supports HS200 at 1.8V

mmc-hs400-1_8v

boolean

The host controller supports HS400 at 1.8V

mmc-hs400-enhanced-strobe

boolean

The host controller and board support eMMC HS400 enhanced strobe.
This mode also requires HS400 at 1.8V and an 8-bit data bus.

pinctrl-1

phandles

Pin configuration/s for the second state. See pinctrl-0.

pinctrl-2

phandles

Pin configuration/s for the third state. See pinctrl-0.

pinctrl-3

phandles

Pin configuration/s for the fourth state. See pinctrl-0.

pinctrl-4

phandles

Pin configuration/s for the fifth state. See pinctrl-0.