maxim,max17262 (on i2c bus)

Vendor: Maxim Integrated Products

Note

An implementation of a driver matching this compatible is available in drivers/sensor/maxim/max17262/max17262.c.

Description

Maxim MAX17262 Fuel Gauge

Properties

Properties not inherited from the base binding file.

Name

Type

Details

design-voltage

int

 
Battery Design Voltage in mV (3300 to 4400)

This property is required.

desired-voltage

int

 
Battery Desired Voltage in mV (3300 to 4400)

This property is required.

desired-charging-current

int

 
Battery Design Charging Current in mA (e.g. 2000)

This property is required.

design-cap

int

 
Battery Capacity in mAh (default 3000)

This property is required.

empty-voltage

int

 
Empty voltage target during load in mV (default 3300)

This property is required.

recovery-voltage

int

 
The voltage level for clearing empty detection in mV (default 3880)

This property is required.

charge-voltage

int

 
Charge voltage in mV

This property is required.

friendly-name

string

 
Human readable string describing the sensor. It can be used to
distinguish multiple instances of the same model (e.g., lid accelerometer
vs. base accelerometer in a laptop) to a host operating system.

This property is defined in the Generic Sensor Property Usages of the HID
Usage Tables specification
(https://usb.org/sites/default/files/hut1_3_0.pdf, section 22.5).

supply-gpios

phandle-array

 
GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

 
Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.