adi,tmc522x-stepper-ctrl
Description
Ramp Generator Motion Control Register-Set for Trinamic stepper controller.
Properties
Properties not inherited from the base binding file.
Name |
Type |
Details |
|---|---|---|
|
|
Motor index (0-based). For TMC522x with single motor, use 0.
This property is required. |
|
|
Motor start velocity in [µsteps/t](unsigned)
Normally, set VSTOP ≥ VSTART! VSTART may be
set to a higher value, when motion distance is
sufficient to allow deceleration to VSTOP.
Default value: Value range: |
|
|
First acceleration between VSTART and V1 in [µsteps/ta²](unsigned)
Default value: Value range: |
|
|
First acceleration / deceleration phase threshold velocity in [µsteps/t] (unsigned)
0: Disables A1 and D1 phase, use AMAX, DMAX only
Default value: Value range: |
|
|
Second acceleration between V1 and VMAX in [µsteps/ta²](unsigned)
This is the acceleration and deceleration value
for velocity mode.
Default value: Value range: |
|
|
Motion ramp target velocity in [µsteps/t] (for positioning ensure VMAX ≥ VSTART) (unsigned)
This is the target velocity in velocity mode. It can be changed any time during a motion.
Default value: Value range: |
|
|
Deceleration between VMAX and V1 in [µsteps/ta²](unsigned)
Default value: Value range: |
|
|
Deceleration between V1 and VSTOP in [µsteps/ta²](unsigned)
Attention: Do not set 0 in positioning mode,
even if V1=0!
Default value: Value range: |
|
|
Motor stop velocity in [µsteps/t] (unsigned)
Attention: Set VSTOP ≥ VSTART!
Attention: Do not set 0 in positioning mode,
minimum 10 recommended!
Default value: Value range: |
|
|
Second phase acceleration for controllers with a six-point ramp
(e.g. TMC522x) in [µsteps/ta²] (unsigned)
Default value: Value range: |
|
|
Second phase threshold velocity for controllers with a six-point ramp
(e.g. TMC522x) in [µsteps/t] (unsigned)
Default value: Value range: |
|
|
Second phase deceleration for controllers with a six-point ramp
(e.g. TMC522x) in [µsteps/ta²] (unsigned)
Default value: Value range: |
Deprecated properties not inherited from the base binding file.
(None)
Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the “adi,tmc522x-stepper-ctrl” compatible.
(None)