Buydisplay 2.8” TFT Touch Shield with Arduino adapter
Overview
The Buydisplay 2.8” TFT Touch Shield has a resolution of 320x240 pixels and is based on the ILI9341 controller. This shield comes with a capacitive FT6206 controller touchscreen. The Arduino adapter is required to use this shield.
More information about the shield and Arduino adapter can be found at the Buydisplay 2.8” TFT Touch Shield website [1] and Arduino adapter website [2].
Pin Assignments
Shield Connector Pin |
Function |
|---|---|
D5 |
Touch Controller IRQ (see note below) |
D7 |
ILI9341 DC (Data/Command) |
D10 |
ILI9341 Reset |
D9 |
ILI9341 SPI CSn |
D11 |
SPI MOSI (Serial Data Input) |
D12 |
SPI MISO (Serial Data Out) |
D13 |
SPI SCK (Serial Clock Input) |
SDA |
FT6206 SDA |
SCL |
FT6206 SCL |
Note
Touch controller IRQ line is not connected by default. You will need
to solder the 5 INT jumper to use it. You will also need to
adjust driver configuration and its Device Tree entry to make use of
it.
Requirements
This shield can only be used with a board which provides a configuration for Arduino connectors and defines node aliases for SPI and GPIO interfaces (see Shields for more details).
Programming
Set --shield buydisplay_2_8_tft_touch_arduino when you invoke
west build. For example:
# From the root of the zephyr repository
west build -b nrf52840dk/nrf52840 --shield buydisplay_2_8_tft_touch_arduino samples/subsys/display/lvgl