DS18B20 1-Wire Temperature Sensor
Overview
This sample shows how to use the Zephyr Sensors API driver for the Maxim DS18B20 temperature sensor.
The sample periodically reads temperature data from the first available DS18B20 device discovered in the system. The sample checks the sensor in polling mode (without interrupt trigger).
Building and Running
The devicetree must have an enabled node with compatible = "maxim,ds18b20";.
See below for examples and common configurations.
If the sensor is not built into your board, start by wiring the sensor pins as shown in the Figure Hardware Configuration of the DS18B20 datasheet at page 10.
Boards with a built-in DS18B20 or a board-specific overlay
Your board may have a DS18B20 node configured in its devicetree by default,
or a board specific overlay file with an DS18B20 node is available.
Make sure this node has status = "okay";, then build and run with:
# From the root of the zephyr repository
west build -b nucleo_g0b1re samples/sensor/ds18b20
west flash
DS18B20 via Arduino Serial pins
Make sure that you have an external circuit to provide an open-drain interface for the 1-Wire bus. Once you have wired the sensor and the serial peripheral on the Arduino header to the 1-Wire bus, build and flash with:
# From the root of the zephyr repository
west build -b None samples/sensor/ds18b20 -- -DDTC_OVERLAY_FILE=arduino_serial.overlay
west flash
The devicetree overlay samples/sensor/ds18b20/arduino_serial.overlay should work on any board with a properly configured Arduino pin-compatible Serial peripheral.
Sample Output
The sample prints output to the serial console. DS18B20 device driver messages are also logged. Refer to your board’s documentation for information on connecting to its serial console.
Here is example output for the default application settings, assuming that only one DS18B20 sensor is connected to the standard Arduino Serial pins:
*** Booting Zephyr OS build zephyr-v2.6.0-1929-gf7abe4a6689e ***
Found device "DS18B20", getting sensor data
[00:00:00.000,039] <dbg> w1_serial: w1_serial_init: w1-serial initialized, with 1 devices
[00:00:00.015,140] <dbg> DS18B20: ds18b20_init: Using external power supply: 1
[00:00:00.021,213] <dbg> DS18B20: ds18b20_init: Init DS18B20: ROM=28b1bb3f070000b9
Temp: 25.040000
Temp: 25.030000