LSM6DSO IMU sensor (I2C on I3C bus)
Overview
This sample sets the date rate of LSM6DSO accelerometer and gyroscope to 12.5Hz and enables a trigger on data ready. It displays on the console the values for accelerometer and gyroscope.
Requirements
This sample uses the LSM6DSO sensor controlled using the I2C interface exposed by the I3C controller. It has been tested using the LSM6DSO on the evaluation board STEVAL-MKI196V1 connected to the I3C header on MIMXRT685-EVK.
References
Building and Running
This project outputs sensor data to the console. It requires an LSM6DSO sensor (for example, the one on evaluation board STEVAL-MKI196V1).
Building on mimxrt685_evk board
west build -b mimxrt685_evk/mimxrt685s/cm33 samples/sensor/lsm6dso_i2c_on_i3c
Board Preparations
mimxrt685_evk
On the board MIMXRT685-EVK, the I3C pins are exposed on the J18 header, where:
SCL is on pin 1
SDA is on pin 2
Internal pull-up is on pin 3 (which is connected to pin 2 already)
Ground is on pin4
LSM6DSO
A LSM6DSO sensor needs to be connected to this header. For example, the evaluation board STEVAL-MKI196V1 can be used. This needs to be prepared so that the LSM6DSO sensor has address 0x6B (i.e. 0xD6, left-shifed).
Sample Output
Testing LSM6DSO sensor in trigger mode.
accel x:-0.650847 ms/2 y:-5.300102 ms/2 z:-8.163114 ms/2
gyro x:-0.167835 dps y:-0.063377 dps z:0.002367 dps
trig_cnt:1
accel x:0.341575 ms/2 y:5.209773 ms/2 z:-7.938787 ms/2
gyro x:-0.034284 dps y:-0.004428 dps z:-0.003512 dps
trig_cnt:2
<repeats endlessly>