NXP i.MX8MN EVK (Cortex-A53)
Overview
i.MX8M Nano LPDDR4 EVK board is based on NXP i.MX8M Nano applications processor, composed of a quad Cortex®-A53 cluster and a single Cortex®-M7 core. Zephyr OS is ported to run on the Cortex®-A53 core.
Board features:
RAM: 2GB LPDDR4
Storage:
SanDisk 16GB eMMC5.1
Micron 32MB QSPI NOR
microSD Socket
Wireless:
WiFi: 2.4/5GHz IEEE 802.11b/g/n
Bluetooth: v4.1
USB:
OTG - 2x type C
Ethernet
PCI-E M.2
Connectors:
40-Pin Dual Row Header
LEDs:
1x Power status LED
1x UART LED
Debug
JTAG 20-pin connector
MicroUSB for UART debug, two COM ports for A53 and M7
More information about the board can be found at the NXP website.
Supported Features
The Zephyr mimx8mn_evk board configuration supports the following hardware features:
Interface |
Controller |
Driver/Component |
|---|---|---|
GIC-v3 |
on-chip |
interrupt controller |
ARM TIMER |
on-chip |
system clock |
UART |
on-chip |
serial port |
Devices
System Clock
This board configuration uses a system clock frequency of 8 MHz.
Serial Port
This board configuration uses a single serial communication channel with the CPU’s UART4.
Programming and Debugging
Copy the compiled zephyr.bin to the first FAT partition of the SD card and
plug the SD card into the board. Power it up and stop the u-boot execution at
prompt.
Use U-Boot to load and kick zephyr.bin:
fatload mmc 1:1 0x93c00000 zephyr.bin; dcache flush; icache flush; dcache off; icache off; go 0x93c00000
Or kick SMP zephyr.bin:
fatload mmc 1:1 0x93c00000 zephyr.bin; dcache flush; icache flush; dcache off; icache off; cpu 2 release 0x93c00000
Use this configuration to run basic Zephyr applications and kernel tests, for example, with the Basic Synchronization sample:
# From the root of the zephyr repository
west build -b imx8mn_evk/mimx8mn6/a53 samples/synchronization
west build -t run
This will build an image with the synchronization sample app, boot it and display the following ram console output:
*** Booting Zephyr OS build zephyr-v3.1.0-3575-g44dd713bd883 ***
thread_a: Hello World from cpu 0 on mimx8mn_evk_a53!
thread_b: Hello World from cpu 0 on mimx8mn_evk_a53!
thread_a: Hello World from cpu 0 on mimx8mn_evk_a53!
thread_b: Hello World from cpu 0 on mimx8mn_evk_a53!
thread_a: Hello World from cpu 0 on mimx8mn_evk_a53!
Use Jailhouse hypervisor, after root cell linux is up:
#jailhouse enable imx8mn.cell
#jailhouse cell create imx8mn-zephyr.cell
#jailhouse cell load 1 zephyr.bin -a 0x93c00000
#jailhouse cell start 1