File system shell example¶
This example provides shell access to a LittleFS file system partition in flash.
A board with LittleFS file system support and UART console
Before starting a build, make sure that the i386 pkgconfig directory is in your search path and that a 32-bit version of libfuse is installed. For more background information on this requirement see Native POSIX execution (native_posix).
west build -b native_posix samples/subsys/shell/fs
See Native POSIX execution (native_posix) on how to connect to the UART.
west build -b reel_board samples/subsys/shell/fs
This target is customized to support the same SPI NOR partition table as the littlefs File System Sample Application.
west build -b particle_xenon samples/subsys/shell/fs
If you want to use the ‘flash load’ command then build the sample with the ‘prj_flash_load.conf’ configuration file. It has defined a larger RX buffer. If the buffer is too small then some data may be lost during transfer of large files.
Once the board has booted, you will be presented with a shell prompt. All file system related commands are available as sub-commands of fs.
Begin by mounting the LittleFS file system.
fs mount littlefs /lfs
Loading filesystem from host PC to flash memory¶
flash load <address> <size>
It allows loading the data via UART, directly into flash memory at a given address. Data must be aligned to a value dependent on the target flash memory, otherwise it will cause an error and nothing will be loaded.
From the host side file system must be loaded with ‘dd’ tool with ‘bs=64’ (if the file is loaded in chunks greater than 64B the data is lost and isn’t received by the Zephyr shell).
Example in Zephyr console:
flash load 0x7a000 0x5000
Example in the host PC:
dd if=filesystem of=/dev/ttyACM0 bs=64
During the transfer there are printed messages indicating how many chunks are already written. After the successful transfer the ‘Read all’ message is printed.
Files System Shell Commands¶
Mount a file system partition to a given mount point
fs mount (littlefs|fat) <path>
List all files and directories in a given path
fs ls [path]
Change current working directory to given path
fs cd [path]
List current working directory
Write hexadecimal numbers to a given file. Optionally a offset in the file can be given.
fs write <path> [-o <offset>] <hex number> ...
Read file and dump in hex and ASCII format
fs read <path>
Truncate a given file
fs trunc <path>
Create a directory
fs mkdir <path>
Remove a file or directory
fs rm <path>
Flash Host Access¶
For the Native POSIX board the flash partitions can be accessed from the host Linux system.
By default the flash partitions are accessible through the directory flash relative to the directory where the build is started.