Enhanced Serial Peripheral Interface (eSPI)
Overview
This sample demonstrates how to use the Enhanced Serial Peripheral Interface (eSPI) API. It shows how to configure and select eSPI controller capabilities as part of a simple eSPI handshake that includes exchanging virtual wire packets.
Standard platform signals are sent virtual wire packets over the bus. Callbacks are registered that will write to the console indicating main eSPI events and when a virtual wire is received.
Building and Running
The sample can be built and executed on boards supporting eSPI. Any pins required for minimum eSPI handshake should be configured. Sample requires a correct harness and fixture setup. Please connect an eSPI device to the testing board. After that for the correct execution of that sample in twister, add into boards’s map-file next fixture settings:
- fixture: espi_device_connect
Sample output
Hello eSPI test <BOARD USED>
eSPI target configured successfully!
eSPI test - callbacks initialization... complete
eSPI test - callbacks registration... complete
eSPI BUS reset 1
eSPI test - Handshake with eSPI controller (host)...
VW channel event 1
OOB channel event 1
1st phase completed
SLP signal changed 1
SLP signal changed 1
SLP signal changed 1
2nd phase completed
PLT_RST changed 1
3rd phase completed
request_temp
OOB transaction completed rcvd: 11 bytes
request_temp
OOB transaction completed rcvd: 5 bytes
eSPI sample completed err: 0
note:: The values shown above might differ depending on the subtests executed.