RTKMIPILCDB00000BE MIPI Display

Overview

The Focus LCDs RTKMIPILCDB00000BE MIPI Display is a 4.5 inch TFT 480x854 pixels capacitive touch panel, and a backlight unit.

This display uses a 26 pin connector header.

Pins Assignment of the Renesas RTKMIPILCDB00000BE MIPI Display

Connector Pin | Function
14 | Touch ctrl I2C SDA
15 | Display backlight enable
16 | Touch ctrl I2C SCL
17 | External interrupt
18 | Display reset

Hardware Requirements:

Supported Renesas RA boards: EK-RA8D1 - 1 x RA Board - 1 x Micro USB cable

Hardware Configuration:

The MIPI Graphics Expansion Port (J58) connects the EK-RA8D1 board to the MIPI Graphics Expansion Board supplied as part of the kit.

Set the configuration switches (SW1) as below to avoid potential failures.

SW1-1 PMOD1	SW1-2 TRACE	SW1-3 CAMERA	SW1-4 ETHA	SW1-5 ETHB	SW1-6 GLCD	SW1-7 SDRAM	SW1-8 I3C
OFF	OFF	OFF	OFF	OFF	ON	ON	OFF

Programming

Set --shield=rtkmipilcdb00000be when you invoke west build. For example:

# From the root of the zephyr repository
west build -b ek_ra8d1 --shield rtkmipilcdb00000be tests/drivers/display/display_read_write