This is the documentation for the latest (main) development branch of Zephyr. If you are looking for the documentation of previous releases, use the drop-down list at the bottom of the left panel and select the desired version.

ARCELI W5500 ETH

Overview

ARCELI W5500 Ethernet is breakout board with SPI bus access over 10 pin header. W5500 [1] is 10/100 MBPS stand alone Ethernet controller with on-board MAC & PHY, 16 KiloBytes for FIFO buffer and SPI serial interface.

Pins Assignment of the W5500 Shield

Shield Connector Pin	Function
RST#	Ethernet Controller’s Reset
CS#	SPI’s Chip Select
SCK	SPI’s ClocK
SDO	SPI’s Slave Data Output (MISO)
SDI	SPI’s Slave Data Input (MISO)
INT	Ethernet Controller’s Interrupt Output

Requirements

This shield/breakout board can be used with any board with SPI interfaces in Arduino header or custom header (by adjusting the overlay).

Programming

Set --shield arceli_eth_w5500 when you invoke west build. For example:

# From the root of the zephyr repository
west build -b nrf52840dk/nrf52840 --shield arceli_eth_w5500 samples/net/dhcpv4_client

References