CY15FRAMKIT-001 Serial F-RAM Development Kit

Overview

CY15FRAMKIT-001 Serial F-RAM Development Kit

CY15FRAMKIT-001 Serial F-RAM Development Kit (Credit: Infineon Technologies)

The Infineon CY15FRAMKIT-001 is an Arduino UNO R3 compatible shield carrying two 256 Kbit serial F-RAM devices:

  • FM24W256, on the Arduino I2C pins.

  • FM25W256, on the Arduino SPI pins.

Both devices operate from 2.7 V to 5.5 V. Jumper J5 selects whether the shield runs from the host board’s 3.3 V or 5 V rail, and the factory setting is 5 V. Set J5 to match the host board’s I/O voltage before fitting the shield.

Requirements

This shield can be used with any board that defines the arduino_header, arduino_i2c and arduino_spi node labels. See Shields for more details.

Pin Assignments

Shield Pin

Function

D10

FM25W256 chip select

D11

FM25W256 SI

D12

FM25W256 SO

D13

FM25W256 SCK

SDA

FM24W256 SDA

SCL

FM24W256 SCL

The shield pulls up SDA and SCL with 4.7 kOhm resistors to its supply rail.

I2C Address

DIP switch SW1 sets the FM24W256 address pins A0 to A2. A switch in the ON position pulls its pin high. The shield ships with all three off, which gives address 0x50.

The devicetree in this shield describes address 0x51, with SW1 position 1 (A0) on and positions 2 and 3 off. Set the switch to match, or change the reg property of the FM24W256 node.

Programming

Set --shield cy15framkit_001 when you invoke west build. For example:

# From the root of the zephyr repository
west build -b kit_pse84_eval/pse846gps2dbzc4a/m33 --shield cy15framkit_001 samples/drivers/eeprom

References

  • CY15FRAMKIT-001 Serial F-RAM Development Kit Guide, document 001-95689.