RAK13800 WisBlock Ethernet Module

Overview

RAK13800 is a WisBlock IO module carrying a WIZnet W5100S 10/100BASE-T Ethernet controller with an RJ-45 jack and magnetics. The controller is strapped for SPI and reaches the WisBlock Core over the IO slot SPI bus.

RAK13800 WisBlock Ethernet Module (Credit: RAKwireless)

RAK13800 WisBlock Ethernet Module (Credit: RAKwireless)

More information about the module can be found at RAK13800 WisBlock Ethernet Module [1].

Requirements

RAK13800 requires a WisBlock Base Board and a WisBlock Core module. It mounts on the WisBlock IO slot, so the base board shield must be listed first.

Pin Assignments

Signal

WisBlock IO pin

CS

25 (SPI_CS)

SCLK

26 (SPI_CLK)

MISO

27 (SPI_MISO)

MOSI

28 (SPI_MOSI)

RESET

31 (IO3)

INT

38 (IO6)

The module also routes RESET to the WisBlock RESET pin and CS to IO5 through resistors that are left unpopulated, so those paths are not described here.

MAC Address

The W5100S has no MAC address of its own and the module carries no EEPROM, so the shield asks for a random locally administered address with zephyr,random-mac-address. The address changes on every boot. An application that needs a stable address overrides it:

&w5100s_rak13800 {
    /delete-property/ zephyr,random-mac-address;
    local-mac-address = [02 00 00 00 00 01];
};

Programming

List the base board shield before this one:

# From the root of the zephyr repository
west build -b rak4631/nrf52840 --shield rakwireless_rak19007 --shield rakwireless_rak13800 samples/net/dhcpv4_client
west flash

References