RAK12006 WisBlock PIR Sensor

Overview

RAK12006 is a WisBlock IO-slot module built around the Senba AM312 PIR sensor. It reports occupancy on WisBlock IO6, which is low while motion is detected. The module draws power from the base board 3V3 rail. An optional 3V3_S supply can be selected with the module resistors. WisBlock IO2 switches that rail and is not controlled by this shield.

IO6 is also wired to sensor slot D, so this shield cannot be combined with a slot D module that uses that pin.

RAK12006 WisBlock PIR Sensor (Credit: RAKwireless)

RAK12006 WisBlock PIR Sensor (Credit: RAKwireless)

More information about the module can be found at RAK12006 WisBlock PIR Sensor.

Requirements

This shield requires a WisBlock core that provides the wisblock_io connector, for example rak4631/nrf52840. The core is mounted on a WisBlock base board such as the RAK19007, which exposes the IO slot.

Programming

Set both shields when you invoke west build. For example when running the Button sample:

# From the root of the zephyr repository
west build -b rak4631/nrf52840 --shield rakwireless_rak19007 --shield rakwireless_rak12006 samples/basic/button

Motion on IO6 is delivered as input event INPUT_KEY_0. The sample prints that event and, when the base board provides led0, turns the user LED on while motion is reported.